Sharper Image Electric Shaver CA900 User Manual

Hot Gel+Lather  
Shaving System  
CA900 Instructions  
Read and save these instructions.  
 
IMPORTANT SAFETY INSTRUCTIONS  
When using an electrical appliance, basic precautions should  
always be observed, including the following:  
READ ALL INSTRUCTIONS BEFORE USING.  
DANGER —  
To reduce the risk of electric shock:  
•Do not reach for the Hot Gel+Lather Shaving System if it has  
fallen into the water. Unplug it immediately.  
•Do not use while bathing or in the shower.  
•Do not place or store the appliance where it can fall or be  
pulled into a tub or sink. Do not place in or drop into water  
or any other liquid.  
•Always unplug the unit from electrical outlet immediately after  
using it.  
•Before cleaning, unplug the appliance.  
3
 
IMPORTANT SAFETY INSTRUCTIONS  
WARNING  
To reduce the risk of electric shock, this appliance has a pola-  
rized plug (one blade is wider than the other). This plug will fit  
in a polarized outlet only one way. If the plug does not fit fully  
in the outlet, reverse the plug. If it still does not fit, contact a  
qualified electrician to install the proper outlet. Do not change  
the plug in any way. Do not attempt to defeat this safety feature.  
An authorized service representative should perform servicing.  
The appliance has no user-serviceable parts.  
•The Hot Gel+Lather Shaving System should never be left  
unattended when the plug is in and the power is on.  
•This appliance should not be used by, on or near children or the  
physically challenged.  
•Use the appliance only for its intended purpose as described in  
this instruction manual.  
•Do not use attachments not recommended by the manufac-  
turer.  
•Do not pull or twist cord, or wrap cord around appliance.  
4
 
IMPORTANT SAFETY INSTRUCTIONS  
•Never operate the appliance if it has a damaged plug or cord,  
if it is not working properly, if it has been dropped or damaged,  
or dropped into water. Return appliance to a service center for  
examination and repair.  
•Never drop or insert objects into openings.  
•Do not use outdoors. Do not operate where aerosol (spray)  
products are being used or where oxygen is being administered.  
•Use only on a level surface.  
•Before attaching to shaving cream/gel cans, unplug the appliance.  
•Keep cord away from heated surfaces.  
•Never use a tool to remove anything from the dispenser.  
To disconnect, turn all controls to OFF, then remove plug  
from outlet.  
•For household use only.  
•Ensure gel nozzle is used for gel and lather nozzle is used  
for lather.  
SAVE THESE INSTRUCTIONS  
5
 
General Instructions  
Variable Temperature Control  
This unit is equipped with a variable temperature-control dial.  
Adjust it until the gel or lather is heated to a comfortable  
temperature.  
Note: At the same temperature control position, the gel tempera-  
ture will be higher than the lather temperature.  
6
 
Parts Diagram  
Variable  
Temperature Control  
Power  
Ready  
OFF button  
Indicator Light  
Power  
Control Cap  
Adjustment Switch  
ON Button  
120V  
Power Cord  
Jack  
Gel Release Button  
Locking Tab  
Cap Removal Tool  
(Located Underneath the unit)  
Protective  
Cylinder  
Gel Nozzle  
Lather Nozzle  
7
 
Steps for Successful Hot Gel & Hot Lather Shaving  
IMPORTANT NOTES  
•Oversize lather cans may not fit into the protective base.  
•The Control Cap works without the protective base.  
Caution: Do not block the dispenser nozzle with your hand,  
as hot steam may be emitted during use or when a can gel or  
lather is low. Replace can when it’s running low. Hold hand to  
the side and under, not in front of the dispenser.  
1. Attach the desired gel or lather nozzle (included) and rotate  
into place. Caution: Always use the correct nozzle for gel  
or lather.  
2. Ensure the ADJUSTMENT switch is in the lather position.  
(See Figure 1.)  
8
 
Steps for Successful Hot Gel & Hot Lather Shaving  
Adjustment  
Switch  
Figure1  
3. To remove the plastic cap from a gel or lather can, use the Cap  
Removal Tool located in the base of the unit. (See Figure 2.)  
Figure 2  
 
Steps for Successful Hot Gel & Hot Lather Shaving  
4. Turn the dispenser over and depress the LOCKING TAB.  
5. Carefully align the gel or lather valve with the center seal of  
the dispenser.  
6. Gently insert the can valve into the seal and release the  
LOCKING TAB. (See Figure 3.)  
Locking Tab  
Center Seal  
Figure 3  
7. Press firmly until the can locks into place.  
Note: If the can valve is not properly inserted into the center seal,  
gel will leak out of the unit.  
10  
 
Steps for Successful Hot Gel & Hot Lather Shaving  
8. To use the dispenser with gel, depress the black CONTROL  
CAP firmly and slide the ADJUSTMENT switch to the outer-  
most GEL position. (See Figure 4.)  
Control Cap  
Adjustment  
Switch  
Figure 4  
ꢀ. To use the dispenser with lather, slide the ADJUSTMENT  
switch to the LATHER position.  
10. Insert attached dispenser and can into protective base  
and rotate clockwise to lock. Plug into wall outlet. Press  
POWER button.  
11. When finished shaving, switch the unit off by pressing  
the POWER button. When not in use, ensure the unit  
is unplugged.  
11  
 
Using Lather  
1. Ensure lather can is inserted correctly into the dispenser.  
(See Figure 3.) Also ensure the lather nozzle is attached to  
the dispenser.  
2. Press the POWER ON button on the top of the dispenser.  
3. After a few minutes, the red indicator illuminates. The unit  
is now ready to dispense hot lather. Hold your hand under the  
dispenser nozzle. With the other hand, press the CONTROL  
CAP until the proper amount of heated lather is dispensed.  
Using Gel  
1. Ensure the gel nozzle is attached to the dispenser as shown  
in Figure 1.  
2. Press down on the top of the dispenser. Simultaneously slide  
the ADJUSTMENT switch until the top locks in place. Gel is  
released into the machine to be heated.  
3. To switch on, press the POWER ON button on the top of  
the cap.  
12  
 
Using Gel  
4. After a few minutes, the red indicator illuminates.  
5. To release heated gel into the palm of your hand, press the  
GEL RELEASE button located on the dispenser nozzle.  
Removing the Shaving Can  
When a gel or lather can is empty, or when traveling, it is neces-  
sary to remove the Hot Gel+Lather Shaving System from the can.  
1. Ensure the unit is unplugged from the outlet.  
2. Holding the can with one hand, turn the CAP on the unit  
counterclockwise. Press the LOCKING TAB with the other  
hand and disconnect the dispenser from the top of the can.  
3. Clean the unit with a damp cloth.  
DO NOT IMMERSE THE UNIT IN WATER!  
13  
 
Troubleshooting Guide  
Problem: Gel is too runny.  
Solution: Adjust TEMPERATURE CONTROL DIAL to a  
lower setting.  
Problem: Unit fails to heat.  
Solution: Ensure the unit is plugged in and turned on. Top red  
light illuminates and blinks. After one to 3 minutes, the red light  
stops blinking and the unit is ready to dispense hot gel/lather.  
Problem: Unit does not dispense gel.  
Solution: Unit is not properly mounted to the gel can. Remove  
unit from the can and reattach, ensuring a secure fit on top of  
the can. Or ensure the lather can is using the lather nozzle and  
perfectly locked.  
Problem: The gel/lather is too hot or too much steam is emitted.  
Solution: Adjust TEMPERATURE CONTROL DIAL to lower  
setting, or replace can if it has a low amount of gel/lather.  
14  
 
WARNING  
KEEP AWAY FROM WATER  
IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS  
OFF, YOU'RE WRONG.  
Everyone knows that electricity and water are a dangerous  
combination. But did you know that an electric appliance is still  
electrically live even if the switch is off?  
If the plug is in, the power is on. So when you are not using your  
appliances, keep them unplugged.  
ALWAYS UNPLUG SMALL APPLIANCES.  
A Public Service Ad from the Association of Home Appliance Manufacturers and  
Underwriters Laboratories, Inc.  
15  
 
Warranty  
What Is Covered  
This warranty covers any defects in materials or workmanship, with the exceptions stated below.  
How Long Coverage Lasts  
This warranty runs for ꢀ0 days from the date of original purchase.  
What Is Not Covered  
This warranty does not cover damage caused by misuse or use other than as intended and described  
in the product instruction manual, or loss or damage to batteries or removable parts.  
What The Sharper Image Will Do  
The Sharper Image warrants this product against defects in materials and workmanship. When repair is  
not practical, The Sharper Image will have the option to replace the defective product with one that is  
the same or has similar functionality.  
How to Obtain Service  
Return the product and receipt, along with a brief explanation of the problem, to:  
T.S.I. - Returns Department  
2901-A West 60th Street  
Little Rock, AR 72209  
If you have questions please feel free to contact our customer service representatives at 1-800-344-5555  
or by email at care@web.sharperimage.com.  
This warranty gives you specific legal rights, and you may have other legal rights that vary from state to state.  
© 2006, 2007 Sharper Image Corporation  
Sharper Image Corporation  
350 The Embarcadero, Sixth Floor  
San Francisco, CA ꢀ4105-1218  
Shop online:  
Actual product may differ slightly from the product described herein.  
IB-7341  
V3 03/07  
 

Sharp Projector XV Z3100 User Manual
Snapper Snow Blower LE3170E User Manual
Soehnle Postal Equipment 7711 User Manual
Sony Car Stereo System XR CA305 User Manual
Sony Computer Monitor PFM 500A2WU PFM 500A2WE PFM 500A2WJ User Manual
Sony Ericsson Cell Phone W900i User Manual
Sony MP3 Player A AY7 100 111 User Manual
StarTechcom TV Cables dvi2hdmia User Manual
Sterling Plumbing Outdoor Shower 72130106 User Manual
T Fal Toaster Avante Deluxe Bagel User Manual