Sony Home Security System Snc Df50n User Manual

3-113-371-11 (1)  
Bottom  
Features  
About the Supplied Manuals  
C
This product is a network camera adopting the 1/3 type CCD. The camera has  
the following features:  
qf LAN port (RJ45)  
Names of Manuals  
The following manuals are supplied with this unit.  
Connect to a hub or computer on the 10BASE-T or 100BASE-TX  
network using a network cable (UTP, category 5).  
High sensitivity (minimum illumination: 0.7lx, F1.3)  
Automatic white balance tracking and adjustment (ATW/ATW-PRO)  
qg I/O (Input/Output) port  
• Manual setting of the camera direction – panning, tilting and rotating  
• Vari-focal auto iris lens as standard equipment. The focal length of the  
lens is from 2.8 mm to 10 mm.  
• High quality CCD and clear dome cover enable high sensitivity.  
• Wide dynamic range (128 times wider than normal) using DynaView  
technology  
Installation Manual (this document)  
The Installation Manual describes the names and functions of the parts of  
the camera, the installation and connections of the camera, etc. Be sure to  
read it before operating the camera.  
This port is provided with a sensor input and two alarm outputs.  
Pin assignment of I/O port  
Network Camera  
Pin No.  
Pin name  
1
2
3 4  
5
6
User’s Guide (stored in the CD-ROM)  
The User’s Guide describes the setup of the camera and the operations  
from the Web browser.  
To open the User’s Guide, see “Using the CD-ROM Manuals” below.  
1
2
3
4
5
6
Sensor In +  
• 24 V AC / 12 V DC power supply system  
Installation Manual  
Before operating the unit, please read this manual thoroughly  
and retain it for future reference.  
Sensor In – (GND)  
Alarm Out 1 +  
Alarm Out 1 –  
Alarm Out 2 +  
Alarm Out 2 –  
3 video compression formats (video codecs) available: JPEG, MPEG4 and  
H.264  
Single codec mode and dual codec mode switchable  
Up to 20 users can access an image of a camera simultaneously.  
You can monitor a high-quality live image of 30 frames per second maximum  
(SNC-DF50N) and 25 frames per second maximum (SNC-DF50P).  
Date/time can be superimposed on the image.  
Using the CD-ROM Manuals  
The supplied CD-ROM disc includes the User’s Guides for this unit  
(Japanese, English, French, German, Spanish, Italian and Chinese  
versions) in PDF format.  
For details on each function and required settings, see the User’s  
Guide stored in the supplied CD-ROM.  
Notes on Use  
Preparations  
The Adobe Reader Version 6.0 or higher must be installed on your  
computer in order to use the User’s Guide stored in the CD-ROM disc.  
For wiring, see “Connecting the I/O port”.  
Operating or storage location  
Do not shoot an extremely bright object (an illumination, the sun, etc.). Also,  
avoid operating or storing the camera in the following locations, as these  
can be a cause of a malfunction.  
qh 12V DC/ 24V AC (power input) connector  
Note  
Connect to a 12V DC or 24V AC power supply system with the  
supplied AC power cord.  
If Adobe Reader is not installed, it may be downloaded from the following  
• Extremely hot or cold places (Operating temperature: –10 °C to  
+50 °C [14 °F to 122 °F])  
• Exposed to direct sunlight for a long time, or close to heating equipment  
(e.g., near heaters)  
• Close to sources of strong magnetism  
• Close to sources of powerful electromagnetic radiation, such as radios or  
TV transmitters  
• Locations subject to strong vibration or shock  
• Humid or dusty locations  
• Locations exposed to rain  
• Locations under the influence of fluorescent light or reflection of a window  
• Under an unsteady light (the image will flicker.)  
qj 5 (line output) jack (minijack, monaural)  
Connect a commercially available speaker system with the built-in  
amplifer.  
Reading the manual in the CD-ROM  
1 Insert the CD-ROM in your CD-ROM drive.  
qk m (microphone input) jack (minijack, monaural)  
A cover page appears automatically in your Web browser.  
If it does not appear automatically in the Web browser, double-click on  
the index.htm file on the CD-ROM.  
Connect a commercially available microphone.  
ql T (video output) connector (BNC type)  
SNC-DF50N/DF50P  
2007 Sony Corporation Printed in China  
Outputs a composite video signal. Connect to a composite video  
input connector of a video monitor, VCR, etc. Use the supplied  
monitor cable for connection.  
2 Select and click on the manual that you want to read.  
This opens the PDF file of the manual.  
Clicking an item in the Table of Contents allows you jump to the relevant  
page.  
w; Screw hole for wire rope  
Ventilation  
Notes  
Owner’s Record  
To prevent heat buildup, do not block air circulation around the camera.  
• The files may not be displayed properly, depending on the version of  
Adobe Reader. In this case, install the latest version, which you can  
download from the URL mentioned in “Preparations” above.  
• If you have lost or damaged the CD-ROM, you can purchase  
replacement. Contact your Sony service representative.  
Monitoring the Camera Image  
The model and serial numbers are located on the bottom. Record these  
numbers in the spaces provided below.  
Transportation  
When transporting the camera, repack it as originally packed at the factory  
or in materials of equal quality.  
Install and connect the camera properly following the instructions in this  
manual, then operate the camera referring to the User’s Guide  
contained in the supplied CD-ROM.  
Refer to these numbers whenever you call upon your Sony dealer  
regarding this product.  
Cleaning  
• Use a blower to remove dust from the lens.  
• Use a soft, dry cloth to clean the external surfaces of the camera.  
Stubborn stains can be removed using a soft cloth dampened with a  
small quantity of detergent solution, then wipe dry.  
Adobe, Acrobat and Acrobat Reader are trademarks of Adobe Systems  
Incorporated in the United States and/or other countries.  
Model No.  
Serial No.  
(continued on the reverse side)  
Location and Function of Part  
WARNING  
The figure shows the camera without the dome casing and the slit cover.  
• Do not use volatile solvents such as alcohol, benzene or thinners as they  
may damage the surface finishes.  
To reduce a risk of fire or electric shock, do not  
expose this product to rain or moisture.  
Side  
A
Note on laser beams  
1 Indoor wiring slit (knockout type)  
Laser beams may damage a CCD. You are cautioned that the surface of a  
CCD should not be exposed to laser beam radiation in an environment where  
a laser beam device is used.  
To avoid electrical shock, do not open the cabinet.  
Refer servicing to qualified personnel only.  
When you wire indoors, cut this part with a nipper or similar and feed the  
cable through it.  
WARNING  
Note  
This installation should be made by a qualified service person and  
should conform to all local codes.  
Take care not to trap the cable between the camera and the ceiling or  
the wall. If the cable is trapped, it may cause a fire or electric shock due  
to breaking.  
Typical CCD Phenomena  
The following phenomena may appear on the monitor screen while you are  
using a CCD color video camera. These phenomena stem from the high  
sensitivity of the CCD image sensors, and do not indicate a fault within the  
camera.  
WARNING  
2 Camera head holder  
3 Lens  
A readily accessible disconnect device shall be incorporated in the  
building installation wiring.  
WARNING (for Installers only)  
Instructions for installing the equipment on the ceiling or the wall:  
After the installation, ensure the connection is capable of supporting at  
least a force of 50 Newtons (N) downwards.  
4 Lens ring fixing screw  
Vertical smear  
A “smear” may appear to extend vertically from very bright subjects, as  
shown below.  
Loosen this screw before adjusting the zoom and focus, then tighten it to  
fix the lens position. The screw can be inserted at one of three points.  
5 Zoom ring  
CAUTION  
The rating label is located on the bottom.  
Video monitor screen  
Pale vertical smear  
Turn this ring to adjust the field of view.  
6 Focus ring  
CAUTION for LAN port  
Turn this ring to adjust the focus.  
For safety reason, do not connect the LAN port to any network devices  
that might have excessive voltage.  
The LAN port of this unit is to be connected only to the devices whose  
power feeding meets the requirements for SELV (Safety Extra Low  
Voltage) and complies with Limited Power Source according to IEC  
60950-1.  
Inside  
B
Very bright subject (such as an  
electric lamp, fluorescent lamp,  
sunlight, or strong reflected light)  
7 Dome casing screw hole  
8 LAN indicator (green)  
This indicator flashes in green when the camera is connected to the  
network. The indicator goes off when the camera is not connected to the  
network.  
Power Supply  
Caution for U.S.A. and Canada  
The SNC-DF50N operates on 24 V AC or 12 V DC.  
The SNC-DF50N automatically detects the power.  
Use a Class 2 power supply which is UL Listed (in the U.S.A) or CSA-  
certified (in Canada).  
This phenomenon is common to CCD imaging elements using an interline  
transfer system, and is caused when electric charge induced by infrared  
radiation deep within the photo sensor is transferred to the resistors.  
9 POWER indicator (green)  
Aliasing  
When the power is supplied to the camera, the camera starts checking  
the system. If the system is normal, this indicator lights up.  
When shooting fine stripes, straight lines or similar patterns, the lines may  
become slightly jagged.  
q; Reset switch  
Caution for other countries  
To reset the camera to the factory default settings, hold down this switch  
with a point and supply the power to the camera.  
Blemishes  
The SNC-DF50N/DF50P operates on 24 V AC or 12 V DC.  
The SNC-DF50N/DF50P automatically detects the power.  
Use a power supply rated 24 V AC or 12 V DC which meets the  
requirements for SELV (Safety Extra Low Voltage) and complies with  
Limited Power Source according to IEC 60950-1.  
A CCD image sensor consists of an array of individual picture elements  
(pixels). A malfunctioning sensor element will show up  
as a single pixel blemish in the image. This is generally not a problem.  
qa Camera installation hole (2 positions)  
qs Camera head fixing screw  
White speckles  
First loose the screw and face the camera head to the desired direction,  
then tighten the screw to fix it.  
For customers in the U.S.A. (SNC-DF50N only)  
When you shoot a poorly illuminated object at a high temperature, small  
This device complies with Part 15 of the FCC Rules. Operation is  
subject to the following two conditions: (1) This device may not cause  
harmful interference, and (2) this device must accept any interference  
received, including interference that may cause undesired operation.  
white dots may appear all over the entire screen image.  
qd MONITOR output jack  
Connect to a video input connector of a monitor. You can adjust the  
camera while looking at the image on the monitor. After adjusting the  
camera, disconnect the cable.  
NOTE: This equipment has been tested and found to comply with the  
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against  
harmful interference when the equipment is operated in a commercial  
environment. This equipment generates, uses, and can radiate radio  
frequency energy and, if not installed and used in accordance with the  
instruction manual, may cause harmful interference to radio  
communications. Operation of this equipment in a residential area is  
likely to cause harmful interference in which case the user will be  
required to correct the interference at his own expense.  
You are cautioned that any changes or modifications not expressly approved  
in this manual could void your authority to operate this equipment.  
All interface cables used to connect peripherals must be shielded in  
order to comply with the limits for a digital device pursuant to Subpart B  
of Part 15 of FCC Rules.  
For Customers in Canada (SNC-DF50N only)  
This Class A digital apparatus complies with Canadian ICES-003.  
Cet appareil numérique de la classe A est conforme à la norme NMB-  
003 du Canada.  
For customers in other countries  
WARNING  
This is a Class A product. In a domestic environment, this product may  
cause radio interference in which case the user may be required to take  
adequate measures.  
In the case that interference should occur, consult your nearest  
authorized Sony service facility.  
ATTENTION  
The electromagnetic fields at specific frequencies may influence the  
picture of the unit.  
• You should keep in mind that the images or audio you are  
monitoring may be protected by privacy and other legal rights, and  
the responsibility for making sure you are complying with  
applicable laws is yours alone.  
• Access to the images and audio is protected only by a user name  
and the password you set up. No further authentication is provided  
nor should you presume that any other protective filtering is done  
by the service. Since the service is Internet-based, there is a risk  
that the image or audio you are monitoring can be viewed or used  
by a third-party via the network.  
SONY IS NOT RESPONSIBLE, AND ASSUMES ABSOLUTELY NO  
LIABILITY TO YOU OR ANYONE ELSE, FOR SERVICE  
INTERRUPTIONS OR DISCONTINUATIONS OR EVEN SERVICE  
CANCELLATION. THE SERVICE IS PROVIDED AS-IS, AND SONY  
DISCLAIMS AND EXCLUDES ALL WARRANTIES, EXPRESS OR  
IMPLIED, WITH RESPECT TO THE SERVICE INCLUDING, BUT  
NOT LIMITED TO, ANY OR ALL IMPLIED WARRANTIES OF  
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE,  
OR THAT IT WILL OPERATE ERROR-FREE OR CONTINUOUSLY.  
A
B
C
I
3
/
O
4
+
2
DC 12V  
AC 24V  
1
LAN  
5
m
1
2
5
6
 

Shure Stereo System AVC20 User Manual
Snapper Lawn Mower 1650 Series User Manual
Sony Camera Lens SEL55F18Z User Manual
Sony DVD Player 4 165 489 111 User Manual
Sony Microcassette Recorder CFS 515S User Manual
Sony MP3 Player DPF D70 User Manual
Spin Master Handheld Game System Bakugan Battle Brawlers User Manual
StarTechcom Computer Drive 35fcreadbk2 User Manual
Sunbeam Electric Shaver SH3200 User Manual
Sylvania DVD Player DVL100D User Manual